LinkOpensChest.wav@lemmy.blahaj.zone to 196@lemmy.blahaj.zone · 6 months agoDelete LinkedIn immediately rulei.ibb.coimagemessage-square16fedilinkarrow-up11arrow-down10
arrow-up11arrow-down1imageDelete LinkedIn immediately rulei.ibb.coLinkOpensChest.wav@lemmy.blahaj.zone to 196@lemmy.blahaj.zone · 6 months agomessage-square16fedilink
minus-squareUriel238 [all pronouns]@lemmy.blahaj.zonelinkfedilinkarrow-up0·6 months agoThe better solution is to use a two-to-one flat adapter piece to make sure each person is centered behind the next.
minus-squaremonsterpiece42@reddthat.comlinkfedilinkarrow-up0·6 months agoDon’t have that type of two-to-one in LEGO bricks. You’d need a 1x2 plate and then plug the head stud into the middle indexing pin of said plate.
minus-squareUriel238 [all pronouns]@lemmy.blahaj.zonelinkfedilinkarrow-up0·6 months agoLEGO should make one. And if not ᴛʜᴇɴ ᴡᴇ ꜱʜᴏᴜʟᴅ ᴩʀɪɴᴛ ᴏɴᴇ.
minus-squareJojo, Lady of the West@lemmy.blahaj.zonelinkfedilinkarrow-up0·6 months agoWhy? The method described above already does the needed task perfectly, and without needing to design and produce a new part. Did you learn nothing from The Human Centipede (2009)?
The better solution is to use a two-to-one flat adapter piece to make sure each person is centered behind the next.
Don’t have that type of two-to-one in LEGO bricks. You’d need a 1x2 plate and then plug the head stud into the middle indexing pin of said plate.
LEGO should make one. And if not ᴛʜᴇɴ ᴡᴇ ꜱʜᴏᴜʟᴅ ᴩʀɪɴᴛ ᴏɴᴇ.
Why? The method described above already does the needed task perfectly, and without needing to design and produce a new part. Did you learn nothing from The Human Centipede (2009)?