I printed this model on my Anycubic Kobra 2 in white PLA with 0.2mm layer height without supports, 3 walls and 7% adaptive cubic infill. Scaled it to 130% which was the largest I could fit on my bed (220x220), it took 8 hours to print.
I had some issues with curved overhangs (especially around the cheek bones) but otherwise it printed in pretty decent quality, not the best but acceptable I would say. I would probably add organic supports for the cheekbones if I print another.
and how mich did that cost you?
$3 or less at a guess
Something like $4USD in filament and a few cents in electricity
What is the purpose of the line printed around the skull but not touching the skull?
Mostly it just gives me a chance to change the z-offset before it starts printing the model. 9/10 times I don’t have to change anything though. I purge and prime the nozzle before this.
Gotcha. So you watch the first layer go down and use this to see if it needs to be adjusted.
Mostly purge and to make sure the bed is level. I don’t bother with it personally. I will use a brim on occasion is i’m printing something significantly taller than it is wide
