Hello all, I am considering on getting a 3D printer. I want to print some stuff for a project. I am relatively new to this. I need the slicer software to be compatible (preferably open source) with linux since that’s what I am using. I have only found the stuff from Prusa to be compatible but they are expensive. I have heard of ender 3 but it is the only os printer by creality and saw the repo is 3yo without updates.

Can I get some suggestions?

  • Honytawk@lemmy.zip
    link
    fedilink
    English
    arrow-up
    0
    ·
    3 months ago

    Also unless you want to work in multiple colours and not have a giant pile of printer poop waste.

    The amount of filament Bambu wastes is ridiculous.

    • ScottE@lemm.ee
      link
      fedilink
      English
      arrow-up
      0
      ·
      3 months ago

      It’s not as much as you might think, plus you have to purge to switch filaments with a single nozzle design. I would argue my Bambu saves filament on the balance because print failure is so low.

    • ShepherdPie@midwest.social
      link
      fedilink
      English
      arrow-up
      0
      ·
      3 months ago

      I think I’m wasting a lot less filament color switching with my new X1C than I ever did with all the failed prints on my old Sidewinder X2. Nothing like checking an 18 hour print at hour 17 and finding that a corner lifted or a support toppled over from all the movement.