I’m looking to buy ups as I have few power outage (last between 1 to 5 seconds max) where I live but I have never used one so don’t know what specs should I check for

Ideally I will plug my 3d printer (about 100-160w when printing), a pi 4 with nvme drive (no idea of wattage) and a mini pc with n100 processor (around 10-20W)

Thanks for your advices

  • SzethFriendOfNimi@lemmy.worldEnglish
    0·
    4 months ago

    And in the case of a 3d printer after so many seconds of now power what id use one for would be to cut off the bed and hotend, list the head and then run the part cooling fan full blast until power went out.

    The print would be ruined but less likely to have heat creep and jams when the power goes out leaving the existing melted plastic to wick up into the heat break when the cooling fan goes out. And less likely, but technically possibly, the nozzle, still not sitting on one piece of plastic with enough heat to scorch or worse.