cm0002@lemmy.world to 3DPrinting@lemmy.worldEnglish · 1 day agoBambu Lab’s Controversial ‘Authorization Control’ Hits Budget 3D Printersall3dp.comexternal-linkmessage-square16fedilinkarrow-up11arrow-down10
arrow-up11arrow-down1external-linkBambu Lab’s Controversial ‘Authorization Control’ Hits Budget 3D Printersall3dp.comcm0002@lemmy.world to 3DPrinting@lemmy.worldEnglish · 1 day agomessage-square16fedilink
minus-squareBronzie@sh.itjust.workslinkfedilinkEnglisharrow-up0·24 hours agoI did this, but experienced a lot of issues connecting to it afterwards. Constant disconnects and it taking several minutes after opening Orca/Studio to find it. Any advice, as I’d like to go back to LAN Mode? Cheers
minus-squareZeoic@lemmy.worldlinkfedilinkEnglisharrow-up0·16 hours agoI currently have my P1S in LAN mode and use HomeAssistant to control it, using thr ha-bambulab integration. Does everything I need
minus-squareBluewing@lemmy.worldlinkfedilinkEnglisharrow-up0·17 hours agoRoll back the firmware to a version that worked. You still can do that.
I did this, but experienced a lot of issues connecting to it afterwards. Constant disconnects and it taking several minutes after opening Orca/Studio to find it.
Any advice, as I’d like to go back to LAN Mode?
Cheers
I currently have my P1S in LAN mode and use HomeAssistant to control it, using thr ha-bambulab integration. Does everything I need
Roll back the firmware to a version that worked. You still can do that.